Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateHVAC Company in Fort Worth, TX
Dalton Heating & Air is the HVAC company Fort Worth homeowners call when a system quits in August, a furnace won’t fire in January, or a heat pump decision needs straight answers. Fort Worth’s housing stock runs heavy to 1990s-2010s slab-on-grade tract homes with attic-mounted horizontal units, which means our crews spend a lot of time in 150-degree attics diagnosing refrigerant leaks and baked-out flex duct. Those conditions shape every repair, every install, and every price we quote. Call (817) 730-5369 and you’ll get a live person, a written price before any work starts, and a full-year written guarantee on every repair we make.
Why Fort Worth Homes Are Different
Fort Worth sits at the western edge of the humid subtropical zone, but summer afternoons run hotter and drier than Dallas because the city has less tree canopy and catches more direct afternoon sun. By July, attic temperatures regularly pass 150°F. That changes the math on every HVAC job here because most of the equipment lives up there. The dominant housing stock is brick veneer tract homes built between the 1990s and 2010s on concrete slabs, with horizontal gas furnaces and evaporator coils packed into low-pitch vented attics. Older neighborhoods like Arlington Heights and the Near Southside are different again: pier-and-beam foundations, closet or basement units, and duct systems that often predate modern sizing standards.
One pattern we see constantly in the Keller-Haslet sprawl north of Loop 820 is a 15- to 20-year-old system failing by early August. The attic flex duct has baked brittle and started leaking, and a 4-ton condenser simply cannot keep up with a 2,600-square-foot two-story with volume ceilings. That combination of attic heat load and duct leakage is the defining HVAC challenge in Fort Worth, and it is the reason undersized return air plenums show up on so many service tickets here. A system that worked fine in March fails in August because the attic got hot and the ducts got leaky, not because the compressor suddenly wore out.
Styles & brands we work with
Our Main Fort Worth Services
Three calls keep our Fort Worth schedule full year-round: air conditioners that stop cooling, furnaces that refuse to fire, and heat pump replacements for homeowners ready to stop patching an old system. Each of these services has its own detailed Fort Worth page linked below.
AC Repair in Fort Worth
Fort Worth air conditioners get pushed hard from May through September, and most failures boil down to a handful of repeat offenders: refrigerant leaks at the evaporator coil, failed capacitors, and duct leakage that makes a healthy compressor look weak. In slab-on-grade tract homes, the coil and much of the ductwork live in an attic that hits 150°F by midday, which shortens the life of both. When a Fort Worth homeowner tells us the upstairs won’t cool but the downstairs is fine, we already know what we are probably looking at. AC Repair in Fort Worth gives you our exact diagnostic process, the price range, and what the repair includes.
Heat Pump Installation in Fort Worth
Heat pumps make more sense in Fort Worth than they did a decade ago. Winter lows are mild enough that a modern heat pump handles the load most days, and the cooling efficiency beats what many older central air systems deliver. The catch in Fort Worth is the attic heat load, so sizing matters. We run a proper load calculation on every heat pump installation, and we look at current duct condition before we bolt a new system onto leaky runs. A heat pump installed on a badly sealed duct system just moves expensive air into a hot attic. Heat Pump Installation in Fort Worth walks through sizing, brands we recommend, and what the install includes.
Furnace Repair in Fort Worth
Fort Worth winters are short, but a January cold snap with a dead furnace is a genuine emergency, especially when the unit is in a vented attic and the house is on a slab with no crawl space to hold warmth. Most furnace failures we see in Fort Worth are ignition-related: failed igniters, flame sensors coated with carbon, or gas valves that won’t hold. Horizontal attic furnaces also collect dust and critter debris faster than closet units, which clogs burners and trips limit switches. Furnace Repair in Fort Worth covers the common fault patterns, the price range, and what our full-year written guarantee covers.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Fort Worth
Our technicians are factory-trained to service Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. We stock common parts for those brands in our local trucks, which means most repairs in Fort Worth wrap up in a single visit. See our brands for the full list of what we work on.
See the difference
Before
After
Before
After
Before
AfterPricing for HVAC Company in Fort Worth, TX
Every job we do in Fort Worth gets a written price before any work begins. That is not an option, an upgrade, or a courtesy. It is how we work. The table below reflects typical totals we write on Fort Worth service tickets and installations.
| Service | Typical range in Fort Worth |
|---|---|
| AC repair (minor: capacitor, contactor) | $150 – $300 |
| AC repair (major: evaporator coil, blower motor) | $350 – $650 |
| Refrigerant recharge with leak seal | $200 – $400 |
| Furnace repair (igniter, flame sensor, pressure switch) | $150 – $350 |
| Furnace repair (gas valve, inducer motor, control board) | $400 – $700 |
| Heat pump repair (reversing valve, defrost board) | $250 – $550 |
| AC installation (standard 3-ton replacement) | $3,500 – $5,500 |
| AC installation (high-efficiency, 4 – 5 ton, two-story) | $5,500 – $7,500 |
| Heat pump installation (standard replacement) | $3,500 – $6,000 |
| Heat pump installation (high-efficiency, ducted) | $6,000 – $7,500 |
| Tune-up (cooling or heating) | $80 – $200 |
In Fort Worth, two things push a repair toward the top of that range: a unit that lives in a tight, hot attic that makes the job physically slower, and a part that is not on the truck and has to run same-day from a supply house. Either way, the written price you approve before we start is the price you pay when we finish. Every repair leaves with a written guarantee that covers the work for a full year, and if the repair fails in that window, we return at no charge.
Neighborhoods We Serve in Fort Worth
Our crews run jobs across the entire Fort Worth metro every day. We schedule by neighborhood cluster so response times hold steady even in peak summer weeks, and most repair calls get a same-day or next-day visit depending on when you call. Representative areas we serve include:
- Arlington Heights
- Near Southside
- Keller-Haslet area
- North Fort Worth
- Wedgwood
Service Area – Cities Near Fort Worth
Dalton Heating & Air dispatches local crews beyond the Fort Worth city limits too. We run regular routes through Haltom City, TX, Colleyville, TX, Mansfield, TX, and Burleson, TX. If you are in one of those cities or anywhere nearby, the same written-price promise, the same full-year repair guarantee, and the same live-answer phone line apply.
Serving Fort Worth, TX - Our Local Coverage Area
We’re based in the Fort Worth area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Fort Worth
Same-day in most cases when you call before early afternoon, and next-day for calls later in the evening. Peak summer weeks fill up faster for installations, but repair calls get priority scheduling because a failed AC in Fort Worth heat is a health risk, not just a comfort problem. Call (817) 730-5369 and a live person will give you a window, not a voicemail queue.
Fort Worth requires a permit for full system replacements, and many HOAs require an approval form before the outdoor condenser goes in. We handle the permit paperwork on every installation and tell you exactly what your HOA needs before we schedule the job. Repairs generally do not require a permit.
No overtime or after-hours surcharge. The price we write before starting is the same price at 2 p.m. on a Tuesday or 2 a.m. on a Saturday during a cold snap. Phone support is staffed by a real person 24 hours a day, and the person who answers can schedule the call.
We serve the full city of Fort Worth plus nearby communities including Haltom City, Colleyville, Mansfield, and Burleson. Dispatch and scheduling are coordinated from the brand’s Dallas-Fort Worth office, and local crews handle the work in Fort Worth daily. If you are in the metro and unsure whether you fall inside our coverage zone, call (817) 730-5369 and we will confirm it in under a minute.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fort Worth Customers Say
"Fixed our AC and the price was fair. Showed up a bit past the window, but he called ahead."
- Dennis R."Tech arrived in uniform right on time. AC wasn't cooling, found a failed capacitor, and replaced it in twenty minutes. The owner is a veteran and the company runs like it."
- Frank O."No pressure to upgrade. He said the old unit had a few years left and fixed the actual problem."
- Jimmy V.